Nueva imagen Enigma2 para MVISION HD700 Linux

COPY IMAGE EASY. Installing Enigma2 the easy way

copy_image_easy.rar --> IMAGE_0618.rar --> COPY EASY IMAGE.pdf


LOAD ENIGMA2 ON 700 LINUX EASILY

LOAD THE STB BOOTLOADER (it’s updated to the last software):
A. Copy the unidis_fw.udf sw (available at the same place) on the usb root folder
B. Plug the usb memory on HD700L
C. Switch off the receiver and when switching it on again press the power button at least 5 seconds, until a “usb” message appears on display.
D. When “done” message is shown, reboot. The STB is ready now to run multiboot (two software, one inside the STB, another one inside the USB).
NOW COPY THE 1 GB USB INSIDE A 4 GB USB, WE NEED:
1º USB IMAGE (IMAGE_0618.rar is from a 1 GB usb, unrar at your pc)
2º PROGRAM win32diskimager-RELEASE-0.2-r23-win32 (matrix air guys know it…)
3º PROGRAM EaseUS Partition Master 9.2.2 (install epm.exe)
PLUG THE USB MEMORY (TESTED USING 4 GB AND 8 GB), FORMATTED, AT PC USB Y CHECK THE LETTER (F, G, H…)


Un saludo