Error reading from IRD (DCU peek) :S pues ese es el error que me trae de cabeza, conecto el deco al pc mediante el jtag me da ese puto error, no puedo hacer nada y encima cuando intento hacer lo de erase al llegar al 11 me da otro error y no consigo cambiarle el firm!!
total que tengo a mi silvestre aqui muerto! como lo resucito y le meto la 1.5? alguien sabe de que es ese fallo? gracias de antemano

Tenta ligar o receptor no interruptor e fazer detect (em jkeys) nos dois segundos seguintes.

Se não der tenta mudar de posição o jumper que está em frente á ficha JTAG.

Antes de se escrever na flash tambem tem que se desligar no interruptor, e depois carregar num botão de OK para carregar a Trap (o jkeys mostra um aviso a dizer para fazer isso).

--

The ERROR reading from DCU Control Register also happens to me sometimes with my homemade JTAG. I was able to solve that by changing the position of jumper that is in front of the JTAG plug in the receiver board. After reprogram I have to place the jumper in its original position or the receiver wont boot.

I also had problems loading the trap. When in jkeys appears a message saying to disconnect the receiver and turn it on in the following two seconds after pressing OK, I first turn on the receiver and press OK in following two seconds. If I press the OK button before turning on the receiver, it won't load the trap.

After appearing the DCU error I always close jkeys and open a new instance. Only one jkeys application can be open at a time. Recently I was also unable to write to the flash without erasing it first.