Iniciado por monkey

hola rafa3333 no lo consigo me sale lo mismo yo lo hago asi cojo el SB4200-FIBERWARE-V9F4 y lo paso a vxworks.st y con eso ejecuto el NETBOOT y me sale esto
Sending reset request...ok
Waiting for CM to boot...ok
Retrieving CM MAC address...ok (00080E0xxxxx)
Sending NetBoot request...ok
Adding 192.168.1xx.1x IP to adapter...ok (already assigned)
Starting FTP server...ok (already started)
New FTP client.
New FTP user (jmcqueen, rickey7)...accepted
FTP file request (/opt/vwMIPS_1_0_1_fcs/target/config/sb4200/vxWorks.st)...ok
FTP client disconnected.

hasta aqui perfecto

y entro en la pagina y hay sale algo asi
Software Version: SB4200-FIBERWARE-V9F4
Hardware Version: 1
MIB Version: II
GUI Version: 1.0
VxWorks Version: 5.3

Network Access Control Object ON
Power Level -5 dBmV The Downstream Power Level reading is a snapshot taken at the time this page was requested. Please Reload/Refresh this Page for a new reading

HFC MAC Address 00:08:0E:xx:xx

erial Number xxxxxxxxxxxxxxxxx
HFC IP Address 10.195.1xx.1xx
HFC MAC Address 00:08:0E:0x:xx:x6
Ethernet IP Address 192.1xx.1xx.1
Ethernet MAC Address 00:08:0E:xxx:x7
CM USB IP Address 192.1xx.1xx.1
CM USB MAC Address 00:08:0E:0x:xx:x7
CPE USB MAC Address 00:08:0E:xx:xxxx
DHCP Information Duration: 1209xxx s
Time: 3600

Frequency 555000000 Hz Locked
Signal to Noise Ratio 35 dB
QAM 256

o el archivo vxworks.st habria que crearlo con un firware espesifico un saludo y gracias por tu ayuda