[QUOTE=lemas;3073035]Te has dejado la flash, los fuses si están correctos. Ahora que lo dominas, empieza por la flash y sigue con, efuse, hfuse, ifuse, para asegurar el tiro.
Saludos.[/QUOTE]
te los puse
creo que es esto)
[B]C:\utilidades\WinAVR\bin>"avrdude" -p m88 -c sp12 -P lpt1 -U flash:w:"C:\utilidades\WinAVR\at88loader.BIN":a -F
[/B]
avrdude: AVR device initialized and ready to accept instructions
Reading | ################################################## | 100% 0.00s
avrdude: Device signature = 0x0f0102
avrdude: Expected signature for ATMEGA88 is 1E 93 0A
avrdude: NOTE: FLASH memory has been specified, an erase cycle will be performed
To disable this feature, specify the -D option.
avrdude: current erase-rewrite cycle count is -50462977 (if being tracked)
avrdude: erasing chip
avrdude: reading input file "C:\utilidades\WinAVR\at88loader.BIN"
avrdude: input file C:\utilidades\WinAVR\at88loader.BIN auto detected as raw
binary avrdude: writing flash (8192 bytes):
Writing | ################################################## | 100% 3.75s
avrdude: 8192 bytes of flash written
avrdude: verifying flash memory against C:\utilidades\WinAVR\at88loader.BIN:
avrdude: load data flash data from input file
C:\utilidades\WinAVR\at88loader.BIN: avrdude: input
file C:\utilidades\WinAVR\at88loader.BIN auto detected as raw binary
avrdude: input file C:\utilidades\WinAVR\at88loader.BIN contains 8192 bytes
avrdude: reading on-chip flash data:
Reading | ################################################## | 100% 3.09s
avrdude: verifying ...
avrdude: verification error, first mismatch at byte 0x0000
0xff != 0x00
avrdude: verification error; content mismatch
avrdude: safemode: lfuse changed! Was 7f, and is now 0
Would you like this fuse to be changed back? [y/n] n
avrdude: safemode: efuse changed! Was 7, and is now 0
Would you like this fuse to be changed back? [y/n] n
avrdude: safemode: Fuses OK
avrdude done. Thank you.
Mi manera de hacer es esta:
Meto comando, que me da ok y sin fallos, pues sigo al siguiente.
Que me da error, pues repito el comando.
Pero desmonto todo el tinglao, pruebo el update y nasti de plasti.