Important: For ALI M3329 STBs only!!!!

To all of you who already tried to load EL_700 E**u-firm (eg sw.eu.v1.3.0.081106.zip) to a GMI based STB board like Silvercrest SL65, SL65/12, Globo Digital 1003/1006, Comag SL35.....

After flashing the soft the system seems to be dead. Its in standby mode!!! By removing the pullup resistor R23 (10k Ohm) on pin 54 you finish the standby mode by hardware. The soft should running now.

The system then requires further HW changes to get it full working. Front panel keyboard and RC must be adapted too.

This is because the SMT board based systems using the ALI pin lead groups different then these boards are GMI based.